IGNITION KIT PERTRONIX IGNITOR II PXN-91589

Use For:

Prestolite Distributors with original equipment Electronic Conversion Module

Pertronix – PNX-91589

Pertronix OEM Part 91589

Pertronix recommends using the “Flame Thrower II” Coil; Item#45011 with this kit & Eliminates the need of external resistance.

Electronic Distributor Conversion Kit, Ignitor II Solid-State Ignition System, Hall Effect, Negative Ground, 12 V, Autolite, Prestolite, Kit

Keep your PerTronix Ignitor or Ignitor II conversion kit in top working condition with these replacement modules. There’s no need to purchase a whole new PerTronix conversion kit; just replace the bad module and you’ll be back on the road. Order the model designed for your specific vehicle application. Cautionthese are not conversion kits; they are replacement modules only.

Cannot be used with solid core spark plug wires!!

Suppression-style or spiral-wound spark plug wires must be used

California EO Approved

Instructions PDF Link: HERE

Carb E0 Number: D-57-22

To see a list of qualifying vehicles, enter CARB E0 Number D-57-22

• Pertronix Ignitor kit
• Replacement breaker plate assembly for Prestolite V8 IDU distributors
• Delivers twice the voltage to the spark plugs increasing horsepower fuel economy and spark plug life
• 2:1 improvement over point type systems in a current fall time for increased coil output
• Rotating cobalt magnets mounted on the distributor shaft trigger an electronic switching module
• No points to burn pit or corrode no moving or rubbing parts to wear out
• Electronics are molded in epoxy eliminating deterioration from dirt oil grease or moisture
• Fits entirely in the distributor with no black box to clutter the engine compartment
• Stable timing no need for any adjustments
• No complicated wiring makes installation easy
• Works great in stock point type distributors as a trigger for multi spark CD ignitions eliminating the need for expensive aftermarket distributors
• Designed for use with most point type coils
• Optimal performance achieved when used with Flame Thrower 40,000 volt coil
• Temperature Range -50 degrees to 300 degrees F
• RPM range 0 to 15,000 RPM
• Legal in all 50 states and Canada
• Guaranteed for 30 months
• Not for use with OMC engines with shift interrupt systems
• Fits Prestolite IDU-7801 distributors
• Fits Volvo Penta engines with Prestolite IDU-7801 distributors from 1986-88
• Replaces Crusader 41090
• Replaces OMC 3854077
• Replaces Prestolite 65-189
• Replaces Volvo Penta 3854077

WARNING- This product can expose you to chemicals which are known to the State of California to cause cancer and reproductive harm. For more information go to www.P65warnings.ca.gov