Pertronix “Ignitor II” Electronic Ignition Conversion Kit 91582

NO LONGER AVAILABLE – SORRY ABOUT THAT

• 1987 and up Prestolite screw down cap distributors – 2 screws only with no clips

• Kit uses stock cap and rotor (not included)

• Not for Prestolite distributors with the original equipment conversion kits
• Note: These kits have a purple and black wire from the module with a trigger wheel pick up.
• If you have OEM ECM,Use Item# PNX-91589
• Fits inside the distributor for a stock look
• Kit includes module and new rotor
• For the PrestoliteScrewDown cap distributor 1987 & Up

Pertronix recommends using the “Flame Thrower II” Coil; Item#45011 with this kit & Eliminates the need of external resistance.

Features include:

Compatible with 12 V negative ground systems and any induction coil

• High-rpm performance is improved when used with the PerTronix Flame-Thrower II super low- resistance (0.6 ohms) 45,000 V coil
• Adaptive dwell maintains peak energy throughout the entire rpm range, reducing misfires while improving engine performance
• Develops, on average, two times more available plug voltage
• Peak current level is reached just prior to spark for maximum energy without heat build-up, increasing coil and module life
• Never change points again!!
• Adjusts spark timing at higher rpm to compensate for the inherent electronic delay
• Senses startup and develops more energy for quicker, easier starting
• Built-in reverse polarity and over current protection shuts down the system, preventing component damage
• Cannot be used with solid core spark plug wiressuppression-style or spiral-wound spark plug wires must be used
• California EO Approved

Instructions PDF Link: HERE

Carb E0 Number: D-57-22

To see a list of qualifying vehicles, enter CARB E0 Number D-57-22

WARNING- This product can expose you to chemicals which are known to the State of California to cause cancer and reproductive harm. For more information go towww.P65warnings.ca.gov